Skullcandy Session 360 Speaker Care and Cleaning Guide

By Skullcandy | Headphones, Earbuds, Gaming, and Speakers | Published: 2026-10-16

Category: Tips & Care

Keep your Session 360 sounding strong with a simple cleaning routine: safe tools, the right technique for its waterproof build, and habits that extend Bluetooth speaker lifespan.

Quick answer

Power off, unplug, then wipe the Session 360 with a soft dry cloth and loosen grime around the grille with a dry soft-bristle brush. For sticky spots, use a barely damp cloth with plain water, then dry fully before charging or playing. Skip harsh chemicals, never soak or run it under a tap, and never charge a wet speaker.

What you need and what to avoid

A five-minute routine twice a month keeps dust and grime from dulling the Session 360's output. Gather a microfiber cloth, a soft-bristle brush (a clean toothbrush works), and a wooden toothpick for seams. Skip paper towels, which shed fibers into the grille, and skip compressed air, which can push debris deeper into the speaker mesh instead of lifting it out.

Use: microfiber cloth, soft-bristle brush, wooden toothpick, plain water.
Avoid: alcohol, ammonia, bleach, abrasive sponges, and any solvent-based cleaner.
Avoid: submerging the speaker or holding it under running water, even though the Session 360 has a rugged, waterproof build.

Match the cleaning to how you actually use it

A speaker that lives on a bike bar collects road dust and sweat; one that hangs in a shower or kitchen collects soap film and cooking mist. Dust responds to dry brushing and a quick wipe. Greasy or sticky film needs a barely damp cloth and a second dry pass. If you clip the Session 360 to a backpack or belt with the strap and magnetic mount, check the strap and mount area too, because grit trapped there can scratch surfaces it presses against.

Battery and charging habits that protect the speaker

Cleaning is only half of upkeep. The Session 360 is rated for up to 20 hours of battery, and that number holds up best when you avoid draining it to zero every cycle. Top it up before long outings, and store it around room temperature rather than in a hot car. Most importantly, never plug in the charging cable while the speaker is wet or damp, because moisture at the charging port is the fastest way to turn a small problem into a dead speaker.

Your Session 360 cleaning steps

Power off and unplug: Turn the Session 360 off and remove the charging cable before you touch it. Common mistake: cleaning while it is plugged in, which risks moisture near the charging port. Checkpoint: the speaker is off and no cable is attached.
Dry-brush the grille and seams: Use a soft-bristle brush in short strokes across the speaker mesh, then work a wooden toothpick gently along the seams and around the strap and magnetic mount. Common mistake: pressing hard or using compressed air, which drives dust deeper into the grille. Checkpoint: loose dust is lifted off, not pushed in.
Wipe with a barely damp cloth: Dampen a microfiber cloth with plain water and wring it out until it is nearly dry, then wipe the body. For sticky residue, repeat with a fresh damp section rather than adding more water. Common mistake: spraying cleaner directly onto the speaker. Checkpoint: no liquid runs or pools on the surface.
Dry completely before use: Buff with a dry microfiber cloth and let the Session 360 air dry until no moisture remains in the seams or around the port. Common mistake: charging or playing immediately after wiping. Checkpoint: the speaker is fully dry before it goes back on the charger.
Store it clean and cool: Keep the speaker at room temperature, away from direct sun and hot cars, and give it a quick dry wipe after outdoor or gym use. Common mistake: tossing a damp or gritty speaker into a bag where grime and moisture sit against it. Next step: repeat the full routine every two to four weeks, or after any especially dusty or sweaty outing.

Session 360 facts that shape your care routine

Session® 360: Session 360 packs punch in a palm-sized, skate wheel-inspired design that goes wherever you do, with a strap and magnetic mount for instant sound anywhere. Its small size and mount points mean more contact surfaces to check for grit, so wipe the strap and magnetic mount as often as the grille.
Session® 360: Up to 20 hours of battery and a rugged, waterproof build. The waterproof build tolerates splashes and damp cloths, but it does not make the speaker safe to soak or charge while wet.
Session® 540: Session 540 is compact, rugged, and easy to carry, straps to your gear or snaps into place with a magnetic mount, and offers 17 hours of battery life. If you own both speakers, the same dry-brush and damp-cloth method works on either, so you can clean them in one sitting.